Segurity Recomendations; Machine Starting-Up And Using Instructions; Position Of The Machine And The Operator, Connection And Disconnection; Adjusting The Height Of The Cutting Head - Sima DAKAR PLUS MONOFASICA Manual De Instrucciones Original

7. SEGURITY RECOMENDATIONS

The machines with electric motor should always be connected to a standard electrical box that has a
circuit breaker and a Residual-current device in accordance with the characteristics of the engine:
2.2kw/3 CV, 230 V SINGLEPHASE 20A circuit breaker 20A/300mA Residual-current device
3kw/4 CV, 230V THREEPHASE , 20A circuit breaker
3kw/4 CV, 400V THREEPHASE 15A circuit breaker
VERY IMPORTANT: Always use earth plug before starting-up the machine.
• Always keep protection elements and the safety protections in their correct positions.
• The damaged electrical cables should be urgently replaced.
• Unplug the machine from the electricity and never manipulate nor operate on the mechanical nor
electrical elements of the machine while the engine is on.
• Never use the machine for purposes other that those it has been designed for.
• Use normalised cables
• Make sure the feeding voltage is in accordance with the voltage indicated in the adhesive label on the
machine.
• Make sure that the extension cords are not in contact with points of high temperature, oil, water,
sharp edges.
• Also avoid trampling or crushing the cables by passing vehicles and do not put any objects on the
machine.
• Do not use high pressure water to clean circuits or electrical elements.
ATTENTION: You are to follow all safety recommendations mentioned in the present user manual and
comply with all labour risks prevention norms in every location.

8. MACHINE STARTING-UP AND USING INSTRUCTIONS

8.1 POSITION OF THE MACHINE AND THE OPERATOR, CONNECTION AND DISCONNECTION

The machine needs to be installed in well illuminated, stable and plane surface, free from any obstacles.
Before starting-up the machine, we should have gone through all necessary safety measures (electrical
connection, stability, protections, etc....) as mentioned in the previous chapters.
When installing the machine, make sure the table on which it will be placed should be a horizontal, non bland
surface.
This machine IS NOT TO BE USED UNDER RAIN AND ALWAYSE WORK IN GOOD ILLUMINATION
CONDITIONS.
To start cutting, the operator should stand in from of the machine. In this position, the operator can easily
manage the cutting head and the piece to be cut. He/she will also have easy access to the electrical plug. (Fig. 4).
Once the power supply cable is connected, the motor and the water puma start-up only by pressing the green
switch button.
The machine can be stopped, simply by pressing the red switch button. (Fig. 4).

8.2 ADJUSTING THE HEIGHT OF THE CUTTING HEAD

The machine is delivered aligned and adjusted for a determined cutting height. If you wish to transform the
machine from Ø300 to Ø350 or the opposite, you have to be careful with the height you want and change the position
of the motor as you can cut the cart with the disk. To change the cutting height, proceed as follows:
ATENTION: This intervention must be effectuated only if the power supply is totally unplugged.
Once the engine has been unplugged from the electricity, loosen and remove the screws (T fig.5) fastening
the cutting bridge with the lateral set squares.
2 Raise the motor platform to (Ø350) or lower it to (Ø300) sliding it with the flumes. Thereafter, tighten the
screws pushing the platform on the end of the flumes as such that the cutting head remains well aligned. With this
system, there is no need to align the disk each time you change the cutting height.
3 You can now plug the machine back to the electricity.
20A/300mA Residual-current device
15A/300mA Residual-current device
-9-
ENGLISH