Tabla de contenido
Publicidad
•
It is recommended to use safety glasses, safety boots, gloves etc. Please always use approved
materials.
•
Always use Individual Protection Equipment (IPE) in accordance with the type of work you are
effectuating.
•
Prohibit strangers to access the place of work of the machine.
•
Work clothes are not supposed to have loose articles that can cling into movable parts of the
machine.
•
When you have to move the machine, unplug the electricity cables and block the moving parts of the
machine.
•
Only the diamond blade specified in this manual should be used.
•
Always keep protection elements and the safety guards in their correct positions.
•
The damaged electrical cables should be urgently replaced.
•
Unplug the machine from the electricity and never manipulate nor operate on the mechanical nor
electrical elements of the machine while the engine is on.
•
Never use the machine for purposes other that those it has been designed for.
•
Use normalised cables
•
Make sure the feeding voltage is in accordance with the voltage indicated in the adhesive label on the
machine.
•
Make sure that the extension cords are not in contact with points of high temperature, oil, water,
sharp edges. Also avoid trampling or crushing the cables by passing vehicles and do not put any
objects on the machine.
•
Do not use high pressure water to clean circuits or electrical elements.
SIMA, S.A. is not responsible for the consequences possibly generated but the inadequate use of the
materials cutting machine DAKAR PLUS model.
9. MAINTENANCE
The DAKAR PLUS table saws require a simple maintenance as per the following operations:
• Change the tray water and clean the machine as much as needed. The tray has a tap for this use. It is
necessary to fill the tray with water until the pump is covered with water.
•
Although the cooling pump has a filter cap, it may get in dirt and debris inside of the cut material to block the
propeller. To prevent this, periodically run the pump in a container with clean water for several minutes. If
necessary, unscrew the filter cap and clean the propeller until it turns freely.
• Remove all possible residuals of cut materials that can cling into the rolling tracks of the cutting bridge.
• Replace as soon as possible electrical cables that cause power cuts, breaking or any other disrepair.
• If the machine is not covered, wrap it with an impermeable cloth.
• At the end of each day, unplug the machine.
• Maintenance operations should be performed by people who the machine and its functioning.
ATENCION: before performing any maintenance or cleaning operations, the electricity cable should be
unplugged.
In case you observe any anomalies or mal functioning, let a technician check the machine.
Take into account the safety recommendations mentioned in this manual.
It is prohibited to independently make any change in some parts, components or characteristics of
the machine. SIMA, S. A. shall in no case be responsible for the consequences that may derive from a
breach of these recommendations.
9.1 SUBSTITUTING A DETERIORATED DISK
The cutting disk is one of the most important elements of a cutting table. A disk in good condition is essential
to get an optimal performance of the machine. Replace it when worn-out, twisted or cracked.
-11-
ENGLISH
Publicidad
Capítulos
Tabla de contenido
