Preparing The Machine For First Use; Programming Your Machine; Water Hardness - Krups ESPRESSERIA AUTOMATIC PREMIUM Manual De Instrucciones

Pull out and fill the
water tank with fresh
water.
Do not fill the water tank with hot water, milk or any other liquid. If you turn on the machine when the water
tank is not in place or not correctly filled (under the "min. " level,), the "fill water tank" light will come on.
This machine will not operate when the tank is empty.
NEVER PUT GROUND COFFEE IN THE COFFEE CONTAINER.
We do not recommend the use of oily or sugar coated or flavored espresso/coffee beans.
These types of beans may damage the machine.
Check that the coffee beans do not contain any foreign particles, as any damage caused by the presence of
foreign particles will void the warranty.
Do not put water into the coffee bean container.
Remember to fit the drip tray to avoid waste water flowing onto the work surface and staining it or scalding you.
Be sure that the drip tray is properly installed to avoid overflow.
Be sure your water tank is clean.
When you first use your machine, it will ask you to set several parameters. If you disconnect your machine, you will be asked to
reset some of these parameters.
Select (rotate)
Use the selector knob to choose a function and increase
or reduce values. Confirm your choice using the OK key.
The machine will ask you to set:

Water hardness

When using for the first time, the appliance may request "filling the machine". Follow the
displayed instructions.

PREPARING THE MACHINE FOR FIRST USE

Replace the tank, press
firmly to insure it's fitted
properly. Close the lid.

PROGRAMMING YOUR MACHINE

Confirm (push)
You can select your desired language from those offered.
Language
Choose either ml or oz as your measurement unit.
Volume unit
You can set the date (mandatory if you use the Claris - Aqua Filter
Date
System cartridge).
Time
You can choose between 12 hour or 24 hour time display.
You can choose the period after which your machine will automati-
Auto-off
cally turn off, from 30 minutes to 4 hours (in 30 minute increments).
You can automatically start pre-heating of your machine at your
Auto-on
chosen time.
You must set your water hardness between 0 and 4. See "Water
Hardness Measurement" section.
You must indicate whether a filter has been installed or not
Water filter
(Claris - Aqua Filter System cartridge).
Open the coffee bean
container lid. Add fresh
coffee or espresso beans.
Press "On / Off" to turn
your machine on. Follow
the instructions that
appear on the "choice of
language" screen.
6
Close the coffee bean
container lid again.
Use the selector knob
to choose a language
(highlighted). Press the
OK key to validate.