Tabla de contenido
Publicidad
Radio, EMC and Safety Regulations
This device complies with part 15 of the Federal Communications
Commission (FCC) rules and with RSS-210 of the Industry Canada (IC).
Operation is subject to the following conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including
interference that may cause undesired operation.
Changes or Modifications not expressly approved by the manufacturer for compliance
could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class
B Digital Device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC RF Radiation Exposure Statement:
This equipment complies with FCC RF radiation exposure limits set forth for an
uncontrolled
environment. This equipment must be installed and operated with a minimum distance
of 30cm between the radiator and your body.
This device has been designed to operate with the supplied antenna only. Use of any
other antenna is strictly prohibited. The supplied antenna has a maximum gain of 0dBi,
and has an impedance of 50 ohms.
We cannot sell these products to distributors or consumers in countries other than
where the wireless Units have been approved for use. If these wireless products are
used outside of the designated areas of the Americas where the devices have been
granted approval, T&D Corporation shall in no manner whatsoever take responsibility
for the usage of these products, nor be liable in any manner for legal consequences
stemming from the usage of these wireless products in unapproved areas.
10
Introducción
Normas de comunicación inalámbrica
Nota importante
measures:
Publicidad
Tabla de contenido
