Standard Message Center (If Equipped) - Ford Explorer 2008 Manual De Instrucciones

Driver Controls
Reprogramming a single HomeLink button
To program a device to HomeLink using a HomeLink button previously
trained, follow these steps:
1. Press and hold the desired HomeLink button. Do NOT release the
button.
2. The indicator light will begin to flash after 20 seconds. Without
releasing the HomeLink button, follow Step 1 in the "Programming"
section.
For questions or comments, contact HomeLink at www.homelink.com
or 1–800–355–3515.

STANDARD MESSAGE CENTER (IF EQUIPPED)

With the ignition in the ON position,
the message center, located on your
instrument cluster, displays
important vehicle information
through a constant monitor of
vehicle systems. You may select
display features on the message center for a display of status. The
system will also notify you of potential vehicle problems with a display of
system warnings followed by an indicator chime.
Selectable features
Press and release the
SELECT/RESET control switch to
scroll and reset the following
functions. Select or reset the
function by holding the
SELECT/RESET button for more
than 2 seconds.
Info menu
This menu displays the following control displays:
• Odometer/Trip Odometer (Trip A and Trip B)
• Distance to Empty
• Average Fuel Economy
• Setup Menu
Odometer/Trip odometer
Refer to Gauges in the Instrument Cluster chapter.
119
2008 Explorer (exp)
Owners Guide (post-2002-fmt)
USA (fus)