WEG CFW500 Guía De Instalación, Configuración Y Operación página 11

ENC Encoder Input Plug-in Module
Table 4: Configurations switches for the encoder supply
+VE
Switch Output
Encoder Supply Switch
Setting Voltage
S2.1 = ON 5 Vdc
+VE S2
S2.1 = OFF 12 Vdc
This module has a connector (Figure A.2 on page
29) to enable the use of the Flash Memory Module
(CFW500-MMF), which allows data transfer between
inverters. For further details on this accessory, refer to
the installation, configuration and operation guide of
the CFW500-MMF.
CFW500 | 11