Advanced Functions - Friedrich Q Chassis Serie Manual De Instalación Y Funcionamiento

External Control Status
The icon illuminates to indicate that the system is being controlled
$MART
remotely.
AUTO FAN
AUTO FAN
The icon illuminates to indicate that the system is receiving a Wi-Fi
connection.

ADVANCED FUNCTIONS

Your unit's advanced functions (Timer, Schedule, Test Mode, and Mainte-
nance Menu). The functions mentioned in the following section may or may
not be available depending on the air conditioner model.
Timer/Schedule Select
AUTO FAN
The control system has:
Timer (factory default) - Allows you to command the unit to turn
ON and OFF at time you program within a 7 day window. Setting
the start, stop and day window can be found later in this manual.
Residential (Schedule #1) -
preprogrammed set of operational parameters that covers 7 days op
of the week with 4 time windows during each day. Each time
window has it's own set of 6 operating parameters. Refer to
Addendum.
14
79
F
SET POINT
$MART
79
F
SET POINT
79
F
SET POINT
and
When selected the unit follows a
Commercial (Schedule #2) - When selected the unit follows a pre-
programmed set of operational parameters that covers 7 days of
the week with 2 time windows during each day. Each time window
has it's own set of 6 operating parameters. Refer to Addendum.
FRR125
1. o change the T
button for 3 sec.
If the Schedule function is available, the system displays the
icon. The display indicates the schedule function that is active.
SCHEDULE
To change to an alternate schedule (2 or 3), press the
If the Schedule function is not available, the Timer icon
the
SCHEDULE
To save and exit this selection, press the TIMER SET button for 3 sec.
(Figure 8).
If there is no button activity for 15 seconds, the function will time out and
leave the original selection. Once the selection is saved or timed out, the
display reverts to the normal display.
FRR126
After pressing the
button for 3 seconds, the display indicates a change to Timer/Scheduler
2. To save and exit this selection, press the TIMER SET button (Figure 8).
FRR136
The display reverts to the normal display.
1
selection, press and hold the TIMER/SCHEDULE
icon.
2
or button, within 15 second of pressing the
79
AUTO FAN
SET POINT
SCHEDULE
FRR137
c i n o +
or button.
shows without
t
tim
SCHEDULE
FRR138
F
FRR136