Friedrich Q Chassis Serie Manual De Instalación Y Funcionamiento página 27

STEP 2. In order to run the power cord to the right of the unit, route
the cord along bottom inside of the unit (See Figures 20 and
21), under the lower left mounting screw embossments (See
Figure 22) and exit the cord through right side cord opening
(See Figure 22) of the decorative front cover. Decorative front
cover will keep cord in place.
Figure 19
FACTORY SETTING WITH LEFT-SIDE
CORD PLACEMENT
Figure 20
NEW CORD ALIGNMENT FOR ROUTING CORD
EXIT TO THE RIGHT OF UNIT
STEP 3.
Figure 21
CLOSE-UP OF
CORD UNDER
LEFT MOUNTING
SCREW
EMBOSSMENT
Figure 22
FRR201
LEFT-SIDE
CORD ROUTING
FRR202
Reinstall the 4 screws removed earlier to secure Decorative
front cover with cord exiting to the front bottom of the unit. (4
screws RETAINED FROM STEP 1)
FRR099
RIGHT-SIDE
CORD ROUTING
FRR200
27