Hoshizaki Snowflake GII SUR-65BG Manual De Operación, Mantenimiento E Instalación página 10

Sno wf lak e GII
a. Touch the ON/OFF key (any changes will not be saved). The working set point can also be
set via the SP parameter.
TEMPERATURE DISPLAY (as detected by probes)
1. Ensure that the control panel is not locked and that no procedure is in progress.
2. Press the DOWN arrow for 4 seconds: the display will show the first probe available.
3. Select the correct probe using the UP and DOWN arrows.
4. Press the SET key.
This table shows the codes for each of the probes.
Label Displayed temperature
Pb1 Cabinet temperature
Pb2 Evaporator temperature
To exit the procedure, press the SET key for 60 seconds or do not operate for 60 seconds. Then press
the ON/OFF key.
Note: if the evaporator probe is not present, the Pb2 code will not be displayed.
TEMPERATURE ALARMS
This is a list of alarms shown by this cabinet.
CODE ALARM TYPE
AL Low temperature alarm
AH High temperature alarm
Id Open door alarm
Alarm recording can only be done while the cabinet is turned on.
When the cause of the alarm is no longer present, the cabinet will return to normal operation.
ACCESS TO ALARM HISTORY
1. Press the DOWN button for 2 seconds to show the first code
2. Press and release the UP button or select LS by pressing the DOWN button
3. Press and release the SET button: one of the codes above will be shown
To select an alarm, press the UP button till AH is shown.
To show alarm information, press and release the SET key (the flashing HACCP LED will stop).
DISPLAY TEXTS AND THEIR MEANING
8.0 Critical values 8.0 °C/°F
Dur The display shows the alarm time
h01 1-hour alarm (cont.)
n15 1 hour and 15-minute alarm
AH Selected alarm
To exit the historical display, press and release the ON/STANDBY button repeatedly.
CRITICAL VALUE
Low cabin temperature during this alarm
High cabin temperature during this alarm
Maximum cabin temperature during this alarm
EN 10