Installing Batteries; Using The Ac Adapter - HoMedics BPA-260-CBL Manual

INSTALLING BATTERIES

1. Press down on latch and lift the battery cover to open
the battery compartment.
2. Install or replace 4 "AA " sized batteries in the battery
compartment according to the indications inside the
compartment.
3. Close the battery cover by pushing in the top end of
the battery door.
Replace the batteries if:
1. The weak battery symbol appears on the display.
2. Nothing appears on the display when the power is
switched on.
As the supplied batteries are for test only, they may be
discharged earlier than batteries you buy in stores. Replace
all batteries at one time (as simultaneous set). Use only
1.5V "AA" alkaline batteries. Remove batteries when unit is
not in use for extended periods of time. Date and time will
need to be reset if batteries are removed or replaced. Clean
contacts on battery and in battery compartment with a soft
dry cloth each time you install batteries.
Note: Batteries are hazardous waste. Do not dispose of
them together with the household garbage.
Battery
Cover
11

USING THE AC ADAPTER

Note: • When the AC adapter is your main power
supply, make sure the adapter plug can be
easily removed from the unit.
• Please unload the batteries when operating with
an AC adapter for an extended period of time.
Leaving the batteries in the compartment for a
long time may cause leakage, which may lead to
damage to the unit.
• No batteries are needed when operating with
an AC adapter.
• Date and time will need to be reset if AC adapter
is unplugged and unit is without batteries.
1. Connect the AC adapter with the AC adapter jack as
shown below.
2. Please use only the AC adapter included with this
monitor.
Connect AC
adapter here
AC Adapter
Input: 100-240V~0.18A 50/60Hz
Output: 6V DC 1A 6W Max
12