Fellinga Tree - Remington RM0815P Manual Para El Usuario

Ocultar thumbs Ver también para RM0815P:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Trigger
Lockout
/
/
/
Trigge'r
Figure 10 - Trigger Lockout
and Trigger
Location
7. Guide saw using light pressure. Do not %rce
saw. The motor will overload and can burn out.
It will do the job better and safer at the rate for
which it was intended.
8. Remove saw from a cut with saw running
at full speed. Stop saw by releasing trigger.
Make sure chain has stopped before setting
saw down.
9. Practice until you can maintain a steady, even
cutting rate.
FELLING
A TREE
(Cutting
Down
a Tree)
_IbWARNING:
• Avoid
kickback.
Kickback
can re-
sult in severe
injury
or death. See
Kickback,
page 5, to avoid
risk of
kickback.
• Do not fell a tree without
ampte skill
or expert help.
• Keep children, animals, and bystand-
ers away from area when felling
a
tree.
• If two or more persons perform buck-
ing and felling operations
at the same
time, provide ample distance between
operations.
Provide
distance
of at
least twice the height of tree being
felled.
WARNING: When felling
a tree, be
aware
of your
surroundings.
Do not
endanger any person, strike utility lines,
or cause property damage, if tree strikes
utility
lines, contact
utility
company
at
once.
Felling is the process of cutting down a tree. Make
sure your footing is firm. Keep feet apart. Divide
your weight evenly on both feet. Follow directions
below to fell a tree.
BEFORE
FELLING
A TREE
1. Bef_)re felling, inspect tree. Make sure there
are no dead limbs or branches that may fall
on you. Study natural lean of tree, location of
larger branches, and wind direction. This will
help you judge which way tree will fall.
2. Clear work area around tree.
3. Plan and clear a retreat path bef_)re felling.
Make retreat path opposite to planned direction
of fall of tree and at 45 ° angle
(see Figure l 1 ).
etreat
th
Direction
of
Fall
Path
Figure
11 - Retreat
Path
From
Tree
4.
Remove
dirt, stones, loose bark, nails, staples,
and wire from tree where you will make felling
cuts.
5.
Stay
on uphill
side when
felling
tree. Tree
could roll or slide downhill
after falling.
13

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Rmi015p769-05152

Tabla de contenido