Installation; Preparation; Preparing The Connection To Chimney - Dovre Kachel 750GH Instrucciones De Instalacion Y Uso

The appliance 750GH is fitted with vermiculite
inner plates.
The appliance 750GH is fitted with a removable de-
ashing hatch.
The appliance 750GM is fitted with cast-iron inner
plates.
The appliance 750GM is fitted with a grate through
which the ash falls.
Additional feature of the 750GM
The appliance is suitable for the burning of wood,
brown coal briquettes and anthracite coal.

Installation

Preparation

Please check the appliance for damage caused
during transport or any other damage or defects
immediately after delivery. The appliance is
attached to the pallet with screws at the bottom.
If you detect damage caused during transport
or any other damage or defects, do not use the
appliance and notify the supplier.
Subject to change because of technical improvements
Remove the removable parts (fire-resistant inner
plates, ash pan, side wall heat shield) from the
appliance before you start installing the appliance.
By removing removable parts, it is easier to
move the appliance and to avoid damage.
Note the location of those removable parts, so
that you have no difficulties in installing the
parts in the right place later on.
1. Open the door.
2. Remove the fire-resistant inner plates.
Cast iron inner plates protect the combustion
chamber and dissipate heat to the
environment.
Fitting the handle
The appliance is supplied with a loose handle, the so-
called "cold hand".
Fit the wooden handle to the adaptor using screw
M8x50 provided; see following figure.
09-20015.088
Preparing the connection to
chimney
When connecting the appliance to the chimney you
have the choice of connecting via either the upper side
or the rear; see following figure.
Plug the outlet that you don't want to use with the
corresponding cover that was supplied.
Install the corresponding connection collar that
was supplied on the outlet that you want to use.
Sealant and materials supplied.
When connecting to the upper side an opening has
to be made in the heat shield. At the spot when the
7