Installing And Connecting - Dovre Kachel 750GH Instrucciones De Instalacion Y Uso

opening has to be made an incision has been made
in the heat shield.
Connecting to the upper side
1. Unscrew the heat shield from the appliance.
2. Shut off the flue gas opening on the rear side of the
appliance with the cover (A) provided. Use the
mounting plate (B) and bolt M6x25 (C) to fit the
cover to the appliance; see the following figure.
3. Fit the connection collar (A) to the flue gas opening
on the upper side using the two screws M8x25 (B)
and the washers (C) and nuts M8 (D); see the
following figure.
8
4. Use the supplied stove sealant for sealing both the
connection collar and the cover with the appliance.
5. Screw the heat shield back onto the appliance.
Connecting to the rear side
1. Unscrew the heat shield from the appliance.
2. Make the opening in the heat shield by cutting the
pre-cut section out of the heat shield using plate
shears.
3. Fit the connection collar to the flue gas opening on
the rear side using the fixing materials.
4. Using the fixing materials shut off the flue gas
opening on the rear side of the appliance with the
cover provided.
5. Use the supplied stove sealant for sealing both the
connection collar and the cover with the appliance.
6. Screw the heat shield back onto the appliance.

Installing and connecting

1. Install the appliance in the right place, and make
sure it is level.
2. Connect the appliance hermetically to the flue.
Subject to change because of technical improvements