Dovre Kachel 750GH Instrucciones De Instalacion Y Uso página 39

2. Tip away the heat shield on the under side of the
appliance and let the shield fall so that it comes
loose from the pin on the under side of the top
plate; see following figure.
3. The adjustable locking cam is now accessible.
Unscrew the bolts 2x M6 and adjust the locking
cam. After that, tighten the screws.
Subject to change because of technical improvements
4. Replace the heat shield by following the
instructions for the removal of the heat shield in
reverse order.
Adjusting the door
Check that the door is properly closed and adjust the
locking cam as necessary.
1. Open the door; the hinge is now visible and
accessible.
2. Unscrew the two bolts M8 (A) and then screw the
two adjustment screws (B) in or out until the door
correctly meets the front; see following figure.
3. Tighten the bolts (A) again and close the filling
door.
Adjusting the air slider
If the air slider (C) of the secondary air inlet does not
move easily, you can adjust the air slider using the
two screws (A) and (B) in the front plate; see following
figure.
15