Troubleshooting - Vicks V4600 Manual De Uso Y Cuidado

Troubleshooting

If your humidifier is not working properly, refer to the following:
Problem
• Power Switch is set to "On"
and the nightlight is off
• Little or no mist is produced
• Water overflows from
Reservoir
• Condensation forms around
humidifier or windows
NOTE: Failure to keep this unit clean from mineral deposits normally contained in any water
supply will affect the efficiency of operation of this unit. Customer failure to follow these
instructions may void the warranty.
Possible Cause
• Unit not plugged in
• No power at outlet
• No water in tank
• Unit is not level
• Mineral deposits on
nebulizer
• Water Tank or Base were
washed with detergent
• Tank may be leaking
• Tank Cap is not tight
• Mist Intensity is set too
high for room size or
pre-existing humidity level.
Solution
• Plug unit in
• Check circuits, fuses, test
outlet.
• Fill Water Tank.
• Place on a level surface.
• Clean nebulizer (refer to
Weekly Care & Cleaning
instructions on page 8)
• Rinse thoroughly with
clean water.
• Check the Tank for leaks
and replace if necessary
• Tighten Tank Cap
• Decrease mist output to
lower setting or open door
to the room.
11