Replacing The Charcoal Filter; Light Replacement - AEG DD8694-M Instrucciones Para El Uso Y La Instalacion

Ocultar thumbs Ver también para DD8694-M:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 46
This filter cannot be washed or regenerated. It must be replaced when the c appears on the
display or at least once every 4 months. The filter saturation alarm has to be activated already
before.
Activation of the alarm signal
• In Recirculation Version Hoods, the Filter Saturation Alarm must be activated on installation
or at a later date.
• Press and hold button e (Delay) for 5 seconds, until confirmation appears on the display:
C flashes twice – Activated Charcoal Filter saturation alarm ACTIVATED.
C flashes once – Activated Charcoal Filter saturation alarm DEACTIVATED.

RePLAcINg THe cHARcOAL FILTeR

Reset of the alarm signal
• Switch off the hood and the lighting.
• Press the D-key until the display is unlit.
Replacing of the filter
• Open the comfort panels pulling them downwards.
• Remove the metal grease filters.
• Remove the saturated charcoal filter by releasing
the fixing hooks
• Fit the new filter and fasten it in its correct posi-
tion.
• Put the metal grease filters in their seats.
• Close the comfort panels.

LIgHT RePLAceMeNT

20 W halogen light.
• Remove the 2 screws fixing the Lighting support,
and pull it out of from the Hood.
• Extract the lamp from the Support
• Replace with another of the same type, making
sure that the two pins are properly inserted in the
lamp holder socket holes.
• Refit the Support, fixing it in place with the two
screws removed as above.
charcoal filter (recycling version)
Lighting
12
MAINTENANCE

Publicidad

Tabla de contenido
loading

Tabla de contenido