Mediclinics E88-UL Manual De Instalación Y Utilizacion página 2

INSTALLATION
Dismantling for installation
• Unscrew the two lockscrews with the special SANIFLOW wrench.
• Remove the cover, taking care not to knock the equipment.
• Handle the cover with care.
Mounting
• Optional methods:
A) Mounting with hose and plug
B) Concealed wiring mounting (recommended)
Automatic machine.
The automatic model has proximity sensors mounted on the cover, close to the
Air outlet.Therefore the sensor has to be connected during the installation.
Once the base fixed to the wall, after the follow-up of all the steps shown in the
Sections "dismantling for installation" and "mounting" the procedure is as follows:
1. Inside the cover you can find the sensors wire fixed by a subjection. Detach
it from its provisional subjection by taking care of not to pull the wire (A).
2. Hold the cover without tightening the wire. Plug it into electronic plate from
the base, into the connector card wich you can find in the middle and right
side of same. There is only a position that fits smooth. Do not force the
connection (B).
3. When mounting the cover, take care that the sensors wire remains under
the black evolute of air ejection. For the assembly, insert the cover into the
base and screw the two lockscrews underneath.
• If opting for the B type connection, put the wiring through before tightening up
the base on the wall.
• Use the template provided for wall fixing.
• Drill 4 holes with diameter of 5/16" (8 mm), taking care to clean the dust.
• Screw the base firmly to the wall using a 1/4" (6÷7 mm) flat-ended screwdriver.
- 2 -
ENGLISH