How To Assemble - Hoover Power Scrub SpinScrub 50 El Manual Del Propietario

NOTE: PHILLIPS SCREWDRIVER NEEDED FOR ASSEMBLY.
ATTACH HANDLE
1. Position upper handle and slide down into carpet
washer base (Fig. 2)
2. Insert both screws and tighten with screwdriver
(Fig. 3).
PLACE SOLUTION/ WATER TANK
3. Position bottom of tank onto Carpet Washer
(Fig. 4).
4. Push tank handle while supporting back of
cleaner with other hand until Solution Tank
clicks into place (Fig. 5).
5. Check to make sure tank is securely latched.
2
5
Actual model may vary from images shown.

HOW TO ASSEMBLE

STORE TOOLS
6. Place tools and hose into Mesh Tool Storage
7. Mesh Tool Storage Bag should not be hung on
8. Mesh Tool Storage Bag can be conveniently
CORD STORAGE
9. Wrap cord around cord hooks for convenient
3
6
6
bag provided.
the Carpet Washer while the Carpet Washer is
in use.
stored either on the back of the unit or hung
elsewhere by the provided hook (Fig. 6).
storage. Attach the plug end to cord.
4
ATTENTION
Prior to use, consult with Carpet Manufacturer
on cleaning recommendations for natural fiber
carpeting (including silk and wool), soft carpeting,
and loop Berber carpeting. Do not use on rugs or
carpet when dry cleaning is recommended.