Activating The Device; Vacuum Setting Adjustment; Set Display Units; Foot Pedal Function - COOK Medical K-MAR-5200 Manual De Usuario

Ocultar thumbs Ver también para K-MAR-5200:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 68
K-MAR-5200 Instructions for Use
WARNING: ELECTRIC SHOCK
HAZARD. Internal circuitry is energised
whenever the Vacuum Pump is
connected to mains power irrespective
of whether the device is on or in
standby.

3.10 Activating the Device

in when mains power was disconnected.

3.11 Vacuum Setting Adjustment

3.12 Set Display Units

The measurement units that the Vacuum Pump can display are mmHg and kPa. This setting is indicated by either
the mmHg Indicator being lit or the kPa Indicator being lit.
The factory setting is mmHg.
To change this setting:
1.
Ensure that the device is in standby mode by using the Standby Touch-Pad.
2.
Press
Adjust Vacuum Touch-Pad Increase once, the Vacuum Display will ash up either:
Indicates mmHg Mode
Indicates kPa Mode
3.
Press
Adjust Vacuum Touch-Pad Increase again to toggle between mmHg mode and kPa mode.
4.
Once the desired setting is achieved, switch the device into active mode.
5.
The appropriate indicator should now be lit up.
6.
The device should be displaying in the appropriate units.

3.13 Foot Pedal Function

The Vacuum Pump has two Foot Pedal settings, Latching and Non–Latching.
The factory setting is Non–Latching.
To determine the setting of the device depress the Foot Pedal and observe the behaviour of the device.
3.13.1 Non-Latching Foot Pedal Function
3.13.2 Latching Foot Pedal Function
1-8
English
1

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido