Toto Acrylic Instrucciones De Instalación página 6

Preparation
1

Clean, level and prepare the floor for installation.

Clean the drain hole area in preparation of setting the drain. The area should be dry and free
of any debris.

Apply plumbers putty around the drain body (with top installed) and pass it through the drain
hole.

Apply Teflon tape to the threaded portion of the drain body.

Apply plumbers putty to the washer and slide it over the bottom of the drain body.

Attach the drain body nut on the drain body and tighten until the nut and washer have created
a seal with the bottom of the bathtub. Do not over tighten.

Place the unit in the exact installed position on the floor. Be sure the tub is resting on the bot-
tom supports and not the acrylic.

Determine the location of the drain pipe in the floor (provided by the installer) by taking meas-
urements of the installed drain with respect to the tub. This should include the position of the
drain footprint on the floor and the depth of the drain body.

Carefully place the unit on a blanket, cardboard, or other clean protective surface so that the
unit is properly supported.
Install Drain body to floor pipe
2

Install the floor pipe using the measurements from the installed drain and tub.

Dry fit the tub with installed drain to the floor pipe.

Unscrew the stopper.

Unscrew the drain body top and remove the drain body from the tub without unthreading the
nut.

Install the drain body (with nut and washer) to the floor pipe.

Re-apply plumbers putty to the washer and/or the drain body top as needed.
3 Install Overflow Hardware

Place the back plate over the screw of the overflow cover.

Align the overflow cover with the bar (installed at the factory) in the overflow hole.

Carefully hand tighten the overflow cover until it stops. Do not over tighten.
ABF Installation without access under the floor
stopper
drain body
top
drain body
washer
nut