Toto Acrylic Instrucciones De Instalación página 7

ABF Installation without access under the floor (continued)
Install Bathtub
4

Apply a generous bead of adhesive or silicone (such as GE 5040 Silicone II) to the bottom of the
tub supports.

Apply a bead of tub and tile caulk (such as GE 7000 Silicone II Paintable Silicone) around the
edge of the base.

Carefully set the tub into position over the drain body.

From inside the tub thread on the drain body top. Do not over tighten.

Be sure the tub is resting on the bottom supports and not the acrylic.
Complete Installation
5

Fill the tub with water to the overflow and drain the tub while inspecting the waste connections below the floor for leaks.

With the bathtub now in place wipe off any excess tub and tile caulk around the bottom edge of the bathtub where it meets the
floor.

Run a bead of tub and tile caulk around the bottom edge of the bathtub where it meets the floor. Wipe off any excess caulk with a
wet cloth.

Replace the stopper.

Be sure to provide the customer with the Installation manual.

Fill out the necessary warranty information on the back off the Owner manual (for AirBaths).
To the installer