Check Installation; Trial Operation - Toto Acrylic Instrucciones De Instalación

Check Installation

8
AirBaths: Make sure the blower has ample unobstructed space to draw air and that the space is clear of dust and debris.
All bathtubs: Make sure the bathtub is level and supported by the feet or wood base or mortar sub-floor and not the flange lip.
Clean Up
9

When cleaning after installation, do not use abrasive cleaners, as they may scratch and dull the surface. Use warm water and a
liquid non-abrasive detergent to clean the surface.

Stubborn stains, paint or tar can be removed with isopropyl (rubbing) alcohol. Rinse well and dry with a soft, clean cloth.

Do not use metal scrapers, wire brushes or other metal tools.

Trial Operation

10

Close the drain.

Fill the bathtub.

Check for leaks from the air jets (AirBath only).

Check for leaks from the drain.

Check plug voltage and verify the AirBath activates when the "ON" button is
pressed. Note: The remote may need synchronization. Cycle power to the AirBath. Within
15 seconds, press and hold the Up Blower and Down Blower buttons for 4 seconds.(AirBath
only - see Owner manual)

Check operation. (AirBath only - see Owner manual)

After operation, drain the bathtub and run the Automatic Drying Cycle. (AirBath only
- see Owner manual)
Preparation
1

Clean, level and prepare the floor for installation.

Place the unit in the exact installed position on the floor. Be sure the tub is resting on the bottom supports and not the acrylic.

Determine the location of the drain pipe on the floor by taking measurements of the drain and waste location underneath the unit.
(Drain and waste locations will vary by model.)

Carefully place the unit on a blanket, cardboard, or other clean protective surface so that the unit is properly supported.

Clean the drain hole area in preparation of setting the drain. The area should be dry and free of any debris.
ABR & ABY Installation (continued)
ABF Installation with access under the floor
Drain
Jet Fitting