Installation; Compressed Air Supply; Power Supply - Truper COPLA-40 Manual De Instrucciones

Installation

Torch
CAUTION
Make sure the torch is
correctly assembled before connecting into the
equipment.
• Assemble all the torch parts in the same order
as shown in the graph.
• When it is assembled connect the torch to the
front panel terminal (A).
• Unroll the torch hose completely.
Grounding Clamp
• Insert the grounding clamp fast connection. Turn one quarter of a turn in a
clockwise direction to secure it in the front panel terminal (B).
• Connect the ground clamp (C) to the piece or work bench.
NOTE If the ground clamp is not making contact correctly, the piece
will not get cut because the cutter will only be operating with the pilot flame.

Compressed Air Supply

CAUTION • The plasma cutter requires a
55 PSI - 70 PSI air compressor.
CAUTION
• Use a moisture filter between the
compressor and the plasma cutter to send totally dry air to
the torch. Otherwise, the cut quality will be seriously
diminished.
• Connect the air-line of the moist filter to the cutter air inlet
in the back panel of the plasma cutter (D).

Power Supply

CAUTION
To prevent electric shock read the
information in the "Power Requirements" section in pages 3
and 5.
• Connect the power cable (E) to the 110 V
voltage.
WARNING Before using, the equipment shall be
correctly grounded. No not remove the ground cable.
Otherwise it causes severe body injuries.
C
/ 220 V work
A
Moist
filter
Compressor
55 PSI-70 PSI
B
D
E
7
ENGLISH