Installation (Smaw) - Truper SOIN-120/160 Instrucciones De Uso

Installation
Connections
CAUTION To prevent electric shock, you need to see
information in section "Electrical Requirements" in pages 3
and 5.
• The fast connections of the electrode holder and the
grounding clamp are inserted and turned, one-quarter of
a turn in a clockwise direction in the front panel output
to get them properly secured.
• Press the upperarrow of the
process selector, so that the
welder works in SMAW (Covered
electrode) mode.
NOTE
The upper led of the selector
will turn on.
Inverse Polarity (A)
• Connect the grounding clamp cable to the negative (-)
clamping screw outlet in the welder.
• Connect the grounding clamp (C) to the work piece.
• Connect the electrode holder cable to the positive (+)
clamping screw outlet in the welder.
This configuration produces more heat in the electrode thus,
producing more penetration with the basic electrodes, making
it ideal to solder thick pieces.
Direct Polarity (B)
• Connect the grounding clamp cable into the outlet (+).
• Connect the grounding clamp (C) to the work piece.
• Connect the electrode holder cable into the outlet (-).
This configuration generates more heat in the work piece
thus, producing less deformation and narrower seams,
making it ideal to solder thin pieces.
• Connect the feeding cable (D) working voltage network
(127 V / 220 V).
The welder automatically detects the working
NOTE
voltage (No type of connection is necessary to be carried out).
Before using the welder shall be correctly
WARNING
grounded. Do not uninstall the ground cable. It could cause
severe personal injury.
C
Metal
work
bench
(SMAW)
Led
C
Set the adequate
electrode for the job
into the electrode holder
A
Inverse Polarity
B
Direct Polarity
D
ENGLISH
7