Oil Change; Oil Filter - Truper GEN-15X Manual De Instrucciones

Regular maintenance and adjustment is needed to get
adequate working conditions in the generator. Service and
check-up should be made according to the table shown
below.
NOTICE
Shut off the motor before any type of
maintenance work. Before you start doing maintenance
double-check the generator will not unexpectedly start
running.

Oil change

To assure full and quick drainage, remove oil contents while
the motor is still warm.
1. Unscrew and remove the oil-
measuring rod.
2. Using counterclockwise direction
unscrew oil drain cap and drain oil.
3. When finishing draining reset
the drain cap.
4. Pour motor oil (SAE-10W30) up
to the rod upper level.
5. Set rod into the filling orifice
and screw back.
Select motor oil with viscosity
adequate for the region average
temperature.
WARNING
Truper ® original spare parts. Using non-original parts could
damage the generator.
Maintenance agenda
We recommend doing maintenance in the generator each
month or hours of operation whichever comes first in the
Periodic Maintenance Table.
WARNING
when in contact with skin for long periods of time. However,
this is almost impossible to happen if using oil in minimal
daily proportions. Washing hands with soap and water is
recommended after working with oil.
NOTICE
Please dispose off oil in an environment friendly
way. We suggest to pour oil in a sealed container and to take
it to your local gas station. Do not dispose with household
waste or pour in the ground.

Oil filter

DRAIN
A dirty oil filter will block air entering the carburetor. Clean
PLUG
regularly to prevent carburetor failure. (Figure 10).
1. Remove the oil filter cap. Remove screw and air filter
LEVEL
MAX.
cover.
2. Wash cartridge with a household detergent and water
solution. Rinse or clean with low ignition degree or non-
flammable solvents. Dry cartridge completely.
For maintenance or repairs use only
Used motor oil is a cause of skin cancer
9