Setting Surface Controls - Kenmore 790. Manual Del Usuario

Setting Surface Controls
Sizes of the Surface Gas
Burners
Your appliance is supplied with the
following 3 different surface gas
burners:
Simmer Burner (5,000 BTU)
2 (or 3 on 36" modeUs) Standard
Burners (9,500 BTU)
o Power Burner (14,200 BTU)
When setting up the range for
the first time, make sure that
the correct Burner Heads,
Left
Gas
Burner Cap Opening
(Standard)
""Ai ....
tandard - _ Burner Head Burner Head
"oo r 9, 00 BTO 9, 00 BTO -*
(
' --_/ Center Rear
Left Front Gas Opening
Gas Opening
Grates are Uocated as shown
in Figure 1,
Extra Large
Burner Cap "_
"POWER"
Burner Head
(14,200 BTU
36" Models
_¢/only
Burner Cap
(Standard)
36" Models only
Small
Burner Cap
Right Rear
Gas Opening
Figure 2
located properly in slot
of each Burner Head
Right Front
Gas Opening Figure 1
Assembly
of the Surface Burner
Heads, Burner Caps,
Burner Grates and F_ue Covers
utis very important to make sure that aHof the Surface Burner Heads,
Surface Burner Caps and Surface Burner G rates are installed correctUy
and at the correct Uocations,
1, PUaceaH 4 (four) or 5 (five) Burner Heads in the correct locations
(See Figure 1), Make sure that the correct Burner Head is placed
with the corresponding Gas opening and that the Electrode is
located properly in the slot of each Burner Head (See Figure 2),
Proper Burner Head placement insures that each Burner will have
the correct spark required for surface gas ignition,
2, Place the correct Burner Caps at each of the burner locations
(Burner Cap Pilot Hole must face up), Each of the 4 (four) Burner
Heads MUST have a Burner Cap installed to insure proper ignition
and gas flame size and must be in place with the Pilot Hole facing
up BEFORE placing the Burner Grates (See Figure 2),
3, Place the 2 (two) or 3 (three) cast iron Burner Grates supplied with
the range, Carefully lift the burners grates on to the cooktop over
the burners, Properly installed Burner Grates will rest with all Grate
legs on the cooktop,
REMEMBER -- DO NOT ALLOW SPILLS, FOOD, CLEANING
AGENTS OR ANY OTHER MATERIAL TO ENTER THE GAS
OPENING. Always keep the Burner Caps and Burner Heads in place
whenever the surface burners are in use,