Panasonic PBX Manual De Instrucciones página 3

PNQW4391ZA-VB.fm Page 3 Sunday, July 13, 2014 3:51 PM
b) Never install telephone jacks in wet locations unless the jack is specifically
designed for wet locations.
c) Never touch uninsulated telephone wires or terminals unless the telephone
line has been disconnected at the network interface.
d) Use caution when installing or modifying telephone lines.
e) Anti-static precautions should be taken during installation.
• Unplug the product from the wall outlet and have it serviced by qualified service
personnel in the following cases:
a) When the power supply cord or plug is damaged or frayed.
b) If liquid has been spilled into the product.
c) If the product has been exposed to rain or water.
d) If the product does not operate according to the operating instructions. Adjust
only the controls that are explained in the operating instructions. Improper
adjustment of other controls may result in damage and may require service by
a qualified technician to restore the product to normal operation.
e) If the product has been dropped or the cabinet has been damaged.
f) If product performance deteriorates.
For the PBX
• Do not insert foreign objects of any kind into this product, as they may touch
dangerous voltage points or short out parts that could result in a fire or electric
shock.
• Do not pull, bend, rest objects on, or chafe the power cord and plug. Damage to
the power cord or plug can cause fire or electric shock.
• Do not attempt to repair the power cord or plug. If the power cord or plug is
damaged or frayed, contact an authorised Panasonic Factory Service Centre for a
replacement.
• Do not leave the slot open if an option service card is not installed after removing
a dummy cover plate. Make sure to insert the slot cover included with the option
service card into the slot.
• When mounting the PBX on a 19-inch rack, only use the 19-inch rack mounting
equipment (attachment bracket, screws) made for use with the PBX.
• If damage to the unit exposes any internal parts, disconnect the power supply cord
immediately and return the unit to your dealer.
• To prevent fires, electric shock, injury, or damage to the product, be sure to follow
these guidelines when performing any wiring or cabling:
3