Bushnell ELITE 1M Manual Del Usuario página 13

The modes can be cycled through in a circular fashion by pressing and releasing the mode button. The order of
modes is as follows: RIFLE HD, RIFLE A, RIFLE B, RIFLE C, RIFLE D, RIFLE E, RIFLE F, RIFLE G, RIFLE
H, RIFLE I, RIFLE J, REG, etc. When the Rifle HD selection is displayed, the "RIFLE" & "HD" icon will flash
and when a "RIFLE: selection is displayed, the "RIFLE" icon and ballistic group will be flashing. When the ( )
is displayed, the message ( ) will flash within the display.
Once the desired distance compensation mode is displayed, select it by pressing and releasing the POWER button.
Following this selection, the current unit of measure, "Y" for yards or "M" for meters will flash in the display and the
SETUP icon is still lit. Pressing the MODE button will toggle the unit of measure. When the desired unit of measure
is displayed, press the POWER button to accept the unit of measure.
If the user chooses RIFLE A-J modes, and after having determined unit of measure, the user has the following options:
1. Variable Sight-In (VSI™) - Allows the rifle hunter to choose from four sight-in distances (100, 150, 200, or 300 yards
or meters) and provides holdover / bullet-drop data in inches, centimeters or MOA. The "SD" (Sight-In Distance)
indicator will turn on and the current Sight-In Distance number will blink within the display (I.e. 100, 150, 200, or
300). The Sight-In Distance options can be cycled through in a circular fashion by pressing and releasing the mode
button. Once the desired Sight-In Distance is displayed, select it by pressing and releasing the power button.
2. And finally, if one of the RIFLE A-J modes was chosen, and as long as unit of measure and a sight-in distance was
selected, you have the option of determining how you would like hold-over / bullet-drop displayed. If measurement
units are in yards, you will be able to choose between inches, or MOA. The "CM" for centimeters or "IN" for inches
will flash in the display and the SETUP icon is still lit. Once the desired ballistic measure is displayed, select it by
pressing and releasing the power button. If units of measure selected previously was Meters, then your hold-over /
bullet-drop will automatically be displayed in centimeters.
13