GE Profile CustomStyle 24 Serie Manual Del Propietário página 7

When Your Refrigerator Is First Plugged In
All panel lights come on fk)r five seconds,
a beep sounds, and lights go off ex(ept as
folh)ws:
PF flashes in tile display. Tou(h SYSTEM
CHECK-RESETto eraseit.
NORMALglows.
WARM TEMPgh)ws until tl_e refiigerator
(ools down. It goes offwhen proper fi)od-
keeping temperature is readmd.
:, Door almm beeper is acfi'aned and DOOR
ALARM glows.
:_CRUSHEDICE glows.
:_ DOOR OPEN flashes if either door is open,
goes out when doors me shut.
:, Night light in ice and water dispenser
is off.
How to Set the Door Alarm
To set tile alarxn press DOORALARMunfil it
glows.
The control beeps if either door is open fin
more than 30 se(onds.
The light goes out and tile beeping stops
when you (h)se the door.
Why the WARM TEMP Light Glows
At first, it's probably because your newly-
installed refligerator hasn't completely
cooled (lox_a_ yet. Wait a few hours for it to
(ool, and then the ligln will go out.
From then on, WARM TEMP will glow
whenever temperatures inside get too high
tin proper tood storage. If this happens,
open the doors only when absolutely
necessmT, and close them as quickly as
possible.
As soon as inside temperatures return to
norxnal, the ligln goes out.
If WARM TEMP reappears and stays on fi)r
hmger than 4 hours, call ti)r sex_'ice.
i_ _ii
ii i
How the Monitor and Diagnostic System Works
The diagnostic code flashes and the control
beeps when someflfing starts to go wrong.
]flnore
than one coded tim(lion requires
attention at the same time, the one with the
highest priority will be displayed first.
Pressing SYSTEMCHECK-RESETwill erase
two codes immediatel}_PFand CI.The dE
and FFcodes can only be enlsed by pressing
SYSTEM CHECK-RESET'after the condition
that cm_sed the code to flash has been
corrected.
SYSTEMCHECK-RESETxfill also evaluate
all other coded flmctions. If NORMALis
lit during the displa)qng of a code, that
flmction is operating properly.
7