Product Description; Initial Operation - Renfert Eco Guia De Inicio Rapido

Product Description

Component groups and functioning elements
See Fig. 1 (on cover page)
1 Mixing tube
2 Sensor
3 Gas valve
4 Knurled nut
5 Hose spout

Initial Operation

The initial operation of the burner may only be carried out by qualified
personnel according to DVGW stipulations or valid national regulations.
Please observe the following:
⇒ Check if the type of gas and the connection pressure of the burner
correspond to the gas supply.
⇒ Check the fit of the connection pipe and that is not damaged.
⇒ Close the gas shut-off valve at the laboratory workbench.
⇒ Slide the certified gas hose (according to DIN 30664 or DVGW
G 5501-P) up to the last groove of the hose connection (5) on the burn-
er. If necessary secure the hose with a clamp or coupling to prevent it
from sliding off.
Operation
Igniting the flame
Caution / risk of burning!
When igniting the burner, turn the mixing tube away from the
user and other objects. Keep your distance! The flame could be big!
⇒ Open the gas shut-off valve at the laboratory workbench (gas isolation
valve).
⇒ Open the gas valve (3) to approx. 1 turn.
⇒ Press the actuation knob (6) in, so that you can hear the gas flowing.
⇒ Ignite the flame immediately!
⇒ After igniting the flame, keep the actuation knob (6) pressed for another
10 seconds until the flame is burning independently. If the flame goes
out, repeat the procedure.
Adjusting the flame
Soft flame:
Strong flame:
turn the knurled nut (4) in an upward direction.
turn the knurled nut (4) in a downward direction.
6 Actuation knob for ignition
safeguard
7 Collection pan
8 Sensor holder
9 Clamping screw
10 Allen key
EN