The Polaris P825 Cleaner Control Unit; Submerging The Cleaner - Polaris P825 Manual Del Propietário

Page 8
4.1

The Polaris P825 Cleaner Control Unit

Surface Control
System™ (SCS)
for wall cleaning
(rough to smooth
surfaces)
Cleaner Error
Indicator
Select Cleaning Surface
• Floor
• Floor and Walls
4.2

Submerging the Cleaner

1. Submerge the cleaner vertically (1) and hold it
under the surface, moving gently from side to
side (2) until the bubbles stop to remove any
air trapped inside (see Figure 12).
2. When the bubbles stop, allow the cleaner to
sink to the bottom of the pool.
3. Verify the cleaner is sitting on the bottom
of the pool. Remove additional air if the
cleaner is still floating.
NOTE: The cable side of the cleaner remains up as long as
the pump is OFF. As soon as you turn the pump ON,
the handle lowers.
SURFACE CONTROL SYSTEM
1 2 3 4
ROUGH SMOOTH
1
Figure 12. Submerge and Remove Trapped Air
LEDs indicating
pump strength for
SCS
Start/Stop
Cleaner
2