The Cleaner Control Unit; Submerging The Cleaner - Polaris 8050 Sport El Manual Del Propietario

Page 8
4.1 Cleaner Control Unit
Surface Control
System™ (SCS)
for wall cleaning
(rough to smooth
surfaces)
Cleaner Error
Indicator
Select Cleaning Surface
• Floor
• Floor and Walls
4.2

Submerging the Cleaner

1. Submerge the cleaner vertically (1) and hold it
under the surface, moving gently from side to
side (2) until the bubbles stop to remove any
air trapped inside (see Figure 12).
2. When the bubbles stop, allow the cleaner to
sink to the bottom of the pool.
3. Verify the cleaner is sitting on the bottom
of the pool. Remove additional air if the
cleaner is still floating.
NOTE: The handle of the cleaner remains up whether the
cleaner is OFF or ON.
SURFACE CONTROL SYSTEM
1 2 3 4
ROUGH SMOOTH
Figure 12. Submerge and Remove Trapped Air
LEDs indicating
pump strength for
SCS
Start/Stop
Cleaner
1
2