Stopping The Cleaner And Removing From The Pool; Rinsing The Cleaner; Cleaning The Filter Canister - Polaris P825 Manual Del Propietário

Page 10
Adjust SCS Wall Climbing Setting:
You can change the wall climbing setting at any time
during cleaner operation with the SCS button. The new
setting will be active when the cleaner climbs the next
wall.
• Press to adjust the wall climbing setting
one level higher.
• One additional LED lights each time you press
the button to indicate stronger grip on the wall.
• To decrease setting, press button to cycle
through back to one LED (lowest setting).
_
1
2
3
+
4
4.5 Stopping the Cleaner
and Removing from the Pool
1. If the cleaner is still in operation, press
to interrupt operation. If cleaning cycle is
complete, begin at Step 2.
2. When the cleaner is within arm's reach, pull
gently on the floating cable to bring the cleaner
handle within arm's reach. Use the handle to lift
the cleaner from the water (see Figure 14).
Never lift the cleaner out of the pool by the
floating cable.
1
Figure 14. Lift Cleaner From Pool with Handle
3. Hold the cleaner vertically over the pool surface
to drain water before removing (see Figure 15).
2
Figure 15. Lift Cleaner From Pool with Handle
4.6

Rinsing the Cleaner

Rinse the cleaner afer every cleaning cycle. Use
slightly soapy clean water, then rinse generously with
clean water. Do not use solvents such as acetone or its
equivalent. Do not let your cleaner dry in direct sunlight
near the pool.
4.7

Cleaning the Filter Canister

Always empty and clean the filter canister at the end of
each cleaning cycle.
WARNING
To avoid electric shock and other hazards which
could result in serious injury or death, disconnect
(unplug) the cleaner from the power source before
performing any cleaning and maintenance.
1. Unplug power to the cleaner at the control unit.
Unplug the control unit from the power source.
2. Press the PUSH 'N' GO
filter canister handle (see Figure 16).
3
button to release the
®