Programming And Configuration; Programming (Or Modifying) Cycle Data - Pixsys ATR 902 Manual Instalador

7

Programming and configuration

There are two programming levels:
1. Cycles programming (for operator/user), to enter time/setpoint values for each
step of cycle.
2. Configuration (for manufacturer/installer of plant), to enter main parameters
(sensor type, output type, intervention type alarm/auxiliary ext.).

7.1 Programming (or modifying) cycle data

• With or without starting setpoint
• With or without timed auxiliary outputs
When controller is in SToP follow the points below.
Press
1 Red display visualizes cY.01
CYCLE
7.1.1 Programming of starting setpoint (if not configured, see
par. 6.1.2)
The selection of an initial setpoint (a specific starting temperature of the cycle)
grants the correct gradient if the kiln is still heat from a previous process.
Press
Red display visualizes 00-5 *.
Green display shows the
2
STEP
"starting setpoint"
Otherwise pass to point 4.
Increases, decreases value on
3
green display.
1 This section includes all available options for the cycle programming. Some of these steps can be
omitted if not all the controller functions are used. We recommend the manufacturer to indicate into
the kiln documentation the correct sequence of operations.
12 - ATR902 - User manual
Display
Display
.
1
At each pression selects the next
cycle ( cY.02 for cycle no.2 up to
cY. 1 5 for cycle 15).
At any time press
programming.
Select starting setpoint (starting
temperature).
Do
Do
to exit
START
STOP