Testing Your Fan - Craftmade PAR52ESP4 Guia De Instalacion

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

11. Testing Your Fan.

It is recommended that you test fan before
finalizing installation. Restore power from
circuit box and light switch (if applicable).
Test fan speeds with the pull chain labeled
FAN. Start at the OFF position (no blade
movement). First pull will set the fan to HI.
Second pull will set the fan to MEDIUM.
Third pull will set the fan to LOW. Fourth pull
will again set the fan to the OFF setting. Test
light with the pull chain labeled LIGHT.
(diagram 1) If fan and/or light do (does) not
function, please refer to "Troubleshooting"
section to solve any issues before
contacting Customer Service.
Turn fan completely off before moving the
reverse switch. Set reverse switch to
recirculate air depending on the season:
- LEFT position in summer (diagram 2)
- RIGHT position in winter (diagram 3)
A ceiling fan will allow you to raise your
thermostat setting in summer and lower
your thermostat setting in winter without
feeling a difference in your comfort.
Important: Reverse switch must be set
either completely LEFT or completely RIGHT
for fan to function. If the reverse switch is set
in the middle position (diagram 4), fan will
not operate.
Note: Do NOT remove weatherproof cover
from reverse switch.
Attach pull chain extensions supplied or
custom pull chain extensions (sold
separately) to ends of the pull chains.
motor housing
light
pull chain
extension
reverse switch
diagram 1
diagram 1
diagram 2
page 9
pull chain
extension
diagram 3
diagram 4
fan

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido