CHANNEL OPERATING FREQUENCIES
To change the operating frequency of a channel:
1 With the transceiver power OFF, press and hold the PTT
switch and Side 1 key while turning the transceiver power
ON.
•
Continue to hold the PTT switch and Side 1 key until the LED
lights orange and the transceiver announces "Self".
2 Release the PTT switch and Side 1 key.
•
The transceiver announces "Channel".
•
Pressing the Side 1 key or Side 2 key will toggle between QT,
DQT, and Channel setup.
3 Press and release the PTT switch, then rotate the Channel
selector to your desired channel.
•
Upon pressing and releasing the PTT switch, a beep will sound
and the transceiver announces "Table zero".
4 Press the Side 1 or Side 2 key to increment/ decrement the
Table number, to select the new channel frequency.
•
Press and hold the Side 1 or Side 2 key to increment/
decrement the number by 5 at a time.
•
Table numbers and their corresponding operating frequencies
are provided in the table on page 14.
•
A voice announcement will inform you of the currently selected
Table number.
5 Press the PTT switch to save the setting.
•
A beep will sound.
•
Repeat steps 3 to 5 to set up another channel.
6 Turn the transceiver power OFF and then ON again to
activate the new settings.
Note: The transceiver will automatically return to normal operation
if no action is performed for 20 seconds.
13