Electrolux Green Manual De Uso Y Mantenimiento Ordinario página 9

LOSS OF SUCTION POWER:
• Be sure lid is on properly.
• Empty dirt receptacle.
• Clean filter.
• Be sure each inlet valve is properly closed.
• Check for hose obstruction.
Plug hose coupling into any inlet valve. Then, as you check each of the other inlet valves,
raise the inlet cover and hold your hand over the opening to check for suction. If there
is normal suction at each inlet, then insert the hose into one of the other inlets. If there
is no suction through the hose at the second inlet, the blockage is in the hose. To clear
the hose obstruction, insert a blunt instrument into the hose (garden hose, wood dowel).
If there is one inlet valve without normal suction and you have checked for hose blockage,
then the blockage is in the pipe system between the blocked inlet valve and the power unit
(see instructions below).
• Clear blockage in pipes
Insert the hose into the inlet valve where there is no suction; hold your hand over the hose
end. Release hand quickly. Repeat several times. If blockage does not clear, contact your
nearest service station/dealer.
POWER UNIT WILL NOT START:
• Reset the overload protection device by following the directions on the Overload
Protection Reset section of the manual.
NOTE: The safety device breaks the circuit of the motor is overloaded.
• Check for blown fuse in main house supply box.
• Unplug the power unit from the electrical outlet and check all wall inlet and motor wiring
connections for loose wires.
POWER UNIT WILL NOT STOP RUNNING:
• Check inside each inlet valve for obstruction of low voltage contacts. If no visual obstruction
can be detected, disconnect the vacuum from the electrical outlet and contact your nearest
service station/dealer.
9