Installation; Unit Placement - Tripp-Lite SRCOOL18K Manual Del Usuario

Installation

Warning: After removing the unit from the shipping container, check for damage or missing parts (refer to the parts list below).
If you notice a problem, visit www.tripplite.com/support for service. Do not attempt to operate a damaged unit.
Accessory Parts List:
SRCOOL18K
2 x Gray 1 x Black
Exhaust Duct Cooling Duct
(Longer Tube) (Shorter Tube)
SRCOOL24K
2 x Gray 2 x Black 2 x Exhaust Duct
Exhaust Duct Cooling Duct
(Longer Tube) (Shorter Tube)

Unit Placement

1
Place the unit on a flat, level surface near a grounded AC outlet rated in accordance with
the unit nameplate (90-110% of specified voltage). Leave adequate space around the unit
for ventilation, with the front and rear not less than 20 inches (51 cm) from walls or other
obstacles. Place the unit in a location with convenient access to a drop ceiling or window to
provide the straightest, shortest path available for the flexible exhaust duct. If you plan to use
the flexible cooling duct to focus cool air on a specific rack enclosure or device, place the unit
near the targeted rack enclosure or device to provide the straightest, shortest path available for
the cooling duct.
Warning: Do not use an extension cord to connect the unit to an AC outlet. Use
only the power cord that came with the unit.
Note: If the unit will operate in a confined space (such as closet), you must supply makeup air
in order to maintain airflow efficiency. A 100 in.
bottom of the door should supply adequate makeup air for a typical closet. Consult applicable
building codes for more information.
Exhaust hose not shown—see Section
Cooling Duct Connection (Optional)
2
The pre-installed louvered vent insert is appropriate for room cooling applications. If you plan to cool a room, skip step
If you plan to use the flexible cooling duct to focus cool air on a specific device or rack enclosure, follow the instructions below.
2-1
Remove the louvered vent insert
and lifting the vent from the unit.
Note: The SRCOOL24K's cooling duct connection allows cool air to be split between two
racks.
2 x Exhaust Duct 2 x Adjustable
Adapter Exhaust Panel
(2 Sections)
2 x Adjustable 4 x Self-Tapping
Adapter Exhaust Panel Screw
(2 Sections)
(645 cm ) or larger vent installed near the
2 2
3 .
A by removing the screws
4 x Self-Tapping Cooling Duct
Screw Adapter (Optional)
Cooling Duct Louvered Vent
Adapter – 2 pcs. Insert
(Optional) (Pre-installed)
B using a Phillips screwdriver
5
Louvered Vent Insert
(Pre-installed)
Drainage ENVIROSENSE
Plug Environmental
(2 Pre-installed) Sensor
100 in.
Confined Spaces)
> 20 in. (51 cm)
1
2 and proceed to step
B
A
2-1
Drainage
Plug
(2 Pre-installed)
SNMP
Configuration
Cable
2 (645 cm 2 )
Vent (For
> 20 in. (51 cm)
3 .