Automatic Buttonholing - Kenmore Sears 385. 19153 Manual De Instrucciones

Automatic buttonholing __
Set the machine
It'1 BHI FOOT N. Jl
Ba_tack
N: Automatic buttonhob foot
f
8H2FOOT N ]
Rounded
J
=(=0 B,3Foot, ]
Keyhote
The machine sews three different types of
buttonhole to meet every sewing need. All three
buttonholes are made in the same way.
The automatic buttonhole foot will gauge the
buttonhole length.
Before you sew buttonholes on the actual
garment, make several practice buttonholes on a
scrap of the same fabric.
t t
1, a. Press the up/down needle position
button to raise the needle to its highest
position.
b. Raise the presser foot,
c, Remove the foot holder,
d, Attach the automatic buttonhole foot
by tightening the foot holder screw,
Thickness_
Dbmeler
2,5 cm (31/32" )
PreSS
BU_loo holder\ _"
_ength
--T-
2. a. Draw both threads toward the left under the foot.
b. Lower the needle to the bottom mark.
c. Lower the presser foot.
d. Open the button holder by pulling it back as shown above.
e. Race the button you intend to use on the button holder of the
automatic buttonhole foot N.
f. Press the back of the holder towards you to secure the button.
NOTE; If the thfckness of button Is more than 0.4 cm (3/16"), measure
thickness and diameter and set the button holder as shown
EXAMPLE: If the button is 2 cm (3/4") in diameter and 0.5 cm
(3/16") in thickness, set the measure 2.5 cm (31/32").
Add thickness and diameter, And use the sum for the setting.
* To be continued on page !17,
114