Briteq BT-W07L 12 Wash Manual De Instrucciones página 12

ENGLISH
ELECTRICAL INSTALLATION + ADDRESSING
Important: The electrical installation should be carried out by qualified personal only,
according to the regulations for electrical and mechanical safety in your country.
Every time you turn the unit on, it will show "BT-W07L12" on the display and move all the motors to their
'home' position and you may hear some noises for about 20 seconds. After that the unit will be ready to
receive DMX signal or run the built-in programs.
YOU CAN OPERATE THE UNIT IN THREE WAYS:
o
By master/slave built-in preprogram function
o
By RF8 OR CA-8 easy controller
o
By universal DMX controller (1MSL, 4MSL, 9CH, 12CH, 16CH and 28CH DMX mode)
 BY MASTER/SLAVE BUILT-IN PREPROGRAM FUNCTION:
Select this function when you want an instant show. By linking the units in master/slave connection, the
first unit will control the other units to give an automatic, sound activated, synchronized light show. Its DMX
input will have nothing plugged into it, and its master-LED will be constantly on and sound-LED will flash to
the music.
Important! This function only works when the blackout mode in the menu of the master is set to
OFF, otherwise nothing will happen! Read more about this option in the "Main Menu" paragraph.
 MASTER has 4 built-in shows: You can select show 1, show 2, show 3 or show 4 directly in the
menu of the master.
 SLAVES have 2 working options: The other units are set to slave mode (slave-LED is constantly on).
In order to create a great light show you can introduce contrast movements (pan/tilt of slave is
inversed)  In the menu of the slave units you can go to option "Slave mode" and select:
"Slave 1" Normal slave: slave works in sync with the master.
o
"Slave 2"  2 light show: slave works in opposite with the master.
o
 BY CA8 EASY CONTROLLER
When used in standalone or master/slave mode we strongly advise you to use the CA-8
"Wired easy controller" or the new DMX remote control is the RF-DMX CONVERTER who
allows the user to control several different types of DMX projectors.
Connect the controller to the jack input of the first unit (master).
STANDBY BUTTON:
Press this button to start/stop blackout mode on all connected units.
MODE/FUNCTION BUTTONS:
With the MODE button you can select 3 different modes:
Stand By Blackout the unit
1. Sync. Strobe
Function 2. Two-light strobe
3. Sound Strobe
Mode LED OFF
BRITEQ
®
Select Fade speed - slow
Show Fade speed - fast
1-4 Fade speed - middle
LED
LED ON
blinking
10/86
OPERATION MANUAL
1.Pan positioning
2.Tilt positioning
3.Dimmer or Color change
LED FAST blinking
BT-W07L12