Gima 28092 Guía De Uso página 21

Nebulizador profesional corsia sin manómetro
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 54
21
inactivity, if it is deformed or broken or if the nozzle is clogged by a dry medicine or medicine
in powder form, etc.
Use the Nosepiece only if prescribed by the doctor. NEVER PUT the bifurcations into the
nose but place them as closely as possible.
Where diseases with risk of infection and microbial contamination are present, it is
recommended to use the accessories and the spray ampoule individually (always
seek medical advice).
The device is equipped with a filter which removes any impurities of the air inhaled from
the compressor. Check the conditions of the filter on a periodical basis or if the device is no
longer efficient. If the filter is too dirty, it shall be replaced.
AIR FILTER REPLACEMENT: The air filter shall be replaced every 25 hours of operation or
when it is too dirty. Open the air filter lid from under the bottom, remove the filter and insert the
new one. Place the lid back. Only use original GIMA filters. The masks and the air hose shall
be replaced when there is evidence of deterioration of their materials.
Expected useful life: More than 1500 operating hours (or 5 years) in accordance with the
standard test and operating conditions. Expected shelf life: up to 5 years from the date of
manufacture.
INSTRUCTIONS FOR USE
• Check the device before each use in order to detect malfunctions and / or damage due to
transport and / or storage.
• When inhaling, the patient must sit upright in a relaxed position at a table and not on an
armchair to avoid compressing the airways and thus compromising the effectiveness of the
treatment.
WARNING: Place the appliance on flat and stable surfaces in order to avoid obstruct-
ing the cooling openings located on its sides.
1. Make sure the power cord is thoroughly unrolled to avoid dangerous overheating. In case
the power cord is damaged, contact GIMA technical assistance for replacement.
2. Prepare the HI-FLO nebulizer opening the upper part and pouring the drug prescribed by
your doctor into the lower tank. Close the nebulizer.
3. Connect the air tube into the air outlet placed above the knob of nebulization.
4. Connect the other end of air tube into the bottom of the nebulizer.
5. Connect the selected accessory to the nebulizer: child mask, adult mask, mouthpiece or
nosepiece.
6. Make sure the air filter is placed properly in its seat on the bottom of the device.
7. Press the ON/OFF switch to position I to start nebulization.
8. To interrupt or stop the treatment press again the ON/OFF switch.
9. Adjust the nebulization speedy by turning the knob towards MIN for longer treatments, or
towards MAX for quicker treatments.
10. At the end of the atomization, set the switch to O and remove the plug from the socket.
11. Wash the nebulizer and its accessories as specified in the "cleaning" section.
12. Store the accessories into the packaging.
ENGLISH

Publicidad

Tabla de contenido
loading

Tabla de contenido