Cover Removal And Replacement; Troubleshooting, Disposal And Limited Warranty - Permobil ROHO HARMONY Manual Del Usuario

Cover Removal and Replacement

Inspect the cover for damage and replace if necessary.
Inspect the foam portion of the product for damage and replace if necessary.
Cover Removal: Unzip the outside and inside zippers. Lift the valve flap. Push the valve through the
opening and into the cover. Remove the contoured foam base and the overlay from the cover.
Cover Replacement: Unzip the cover. With the front edge first and the flat surface facing down,
insert the contoured foam base into the bottom section of the cover. With the front edge first and the
air cells facing up, insert the overlay into the top section of the cover. Open the valve flap. Reach into
the top section of the cover and push the inflation valve through the opening beneath the valve flap.
Close the valve flap and close both zippers. If hook fastener strips were removed prior to washing,
replace the strips.
Troubleshooting
For additional assistance, contact your clinical caregiver, distributor, or ROHO, Inc.
Not Holding Air - Inspect for inflation valve and hose damage. Confirm that the inflation valve is
completely closed. Look for holes in the cushion. If very small holes or no holes are visible, follow
the instructions in the Repair Kit provided with your product. For inflation valve or hose damage,
or for large holes or leaks in the cushion, see the Limited Warranty supplement provided with your
product, or contact Customer Care.
Not Able To Inflate or Deflate Cushion - Confirm that the inflation valve is open. Inspect the
inflation valve and hose for damage.
Uncomfortable / Unstable - Confirm that:
- the cushion overlay is not over-inflated (See C
- the air cells and the top of the cover are facing up.
- the cushion is centered beneath the individual.
- the cushion is properly sized to the individual and the wheelchair.
Allow the individual at least one hour to adjust to the cushion.
The Cushion Slides on the Wheelchair - Make sure the non-skid bottom of the cushion cover is
facing down. Use directional labels on the cushion and on the cover to orient the cushion. Use
hook and loop fasteners to further secure the cushion to the wheelchair.
Disposal
The components of the products in this manual are associated with no known environmental
hazards when properly used and when disposed of in accordance with all local/regional regulations.
Incineration must be performed by a qualified, licensed waste management facility.
Limited Warranty
Limited Warranty Term: 18 months from the date the product was originally purchased. The warranty
does not apply to punctures, tears, burns or misuse, nor does it apply to the removable cover. See also the
Limited Warranty supplement provided with your product, or contact Customer Care.
ROHO HARMONY Cushion Operation Manual
ushion
5
A .)
djustment