Programming; Remote Control; Wireless Keyless Entry; To Erase The Memory - LiftMaster Premium Serie Instrucciones De Uso

Programming

Remote Control

Below are the steps to program a new or existing
remote control. Test remote control before
reprogramming.
1. Press and release the LEARN
Button on the garage door
opener.
2. Press and hold the button on the
remote control that you wish to
use. Release the button when
the garage door opener lights
blink or two clicks are heard.
1. Press the LEARN button on the door
control to enter Programming Mode.
2. Press the LEARN button again, the LED
will fl ash once.
3. Press the button on the remote control
that you wish to operate your garage
door.
If your vehicle is equipped with a Homelink
require an external adapter depending on the make,
model, and year of your vehicle.
Visit www.homelink.com for additional information.

Wireless Keyless Entry

Refer to the instructions provided with your
keyless entry OR go to LiftMaster.com to download
instructions.
OR
® , you may

To Erase the Memory

Erase ALL Remote Controls and Keyless Entries
Press and hold the LEARN button
until the LED goes out
(approximately 6 seconds).
All remote controls and
keyless entries are now erased.
Erase ALL Devices
(Including myQ enabled accessories)
1. Press and hold the LEARN button until the LED
goes out (approximately 6 seconds).
2. Immediately press and hold the LEARN button until
the LED goes out. All codes are now erased.
Erase the Wi-Fi Network from the
Garage Door Opener
Press and hold the adjustment
button until 3 beeps are heard
(approximately 6 seconds).
Erase a myQ Account
Go to myLiftMaster.com to delete your myQ account.
LEARN
Button
Adjustment Button
7