Travel Limit Settings; Programming; Remote Control; Partial Open Setting - LiftMaster SL 600 Manual De Instalación, Operación Y Manutención

TRAVEL LIMIT SETTINGS

The travel limits can be set when the gate is closed or opened.
1. Press and hold the
2. Press the remote control or
3. The gate will open or close and stop when the limit switch bracket reaches the switch spring. The
gate operator will save the setting information.
The operator should move in the close direction fi rst when setting the limits. If the gate moves in the
open direction fl ip the #5 dip switch to the opposite position.
NOTE: The gate operator will exit programming after 30 seconds of inactivity.

PROGRAMMING

Remote Control

1. Press and release the
2. Press the remote control button that you would like to program.
The operator will automatically exit learn mode (LED1 will fl ash and go out) if programming is
successful. To program additional Security+ 2.0™ remote controls or remote control buttons, repeat
the programming steps above. Press the LEARN button a second time to exit programming at any time.

Partial Open Setting

1. Press and release the
2. Press and release the
3. Press the remote control button that you would like to program to the partial open setting (must be
different than button controlling normal operation).
NOTICE: Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Any changes or modifi cations not expressly approved by the party responsible for this product could void the user's authority to operate the equipment.
This device is designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
SBC
button for 5 seconds. The DL5 will fl ash.
button.
SBC
LEARN
button, LED1 will light.
LEARN
button, LED1 will light.
LEARN
button again, LED1 will begin fl ashing.
18