Programming; To Erase All Codes; To Add Or Reprogram A Hand-Held Remote Control; Using The Door Control - LiftMaster MERIK SECURITY+ 790LMK Manual Del Propietário

PROGRAMMING

NOTICE: If this Security ✚
®
of the garage door opener, which provides security against code-theft devices, will be circumvented. The owner of the copyright in
the garage door opener does not authorize the purchaser or supplier of the non-rolling code transmitter to circumvent that technical
measure.
Your garage door opener has already been programmed at the factory to operate with your hand-held remote control. The door will
open and close when you press the large push button.
Below are instructions for programming your opener to operate with additional 315 MHz Security✚
USING THE LIGHTED DOOR CONTROL
1. Remove the cover from the Lighted Door
Control.
2. Press and hold the button on the hand-held
remote* that you wish to operate your
garage door.
3. While holding the remote button, press and
hold the "A" button on the Lighted Door
Control.
4. Continue holding both buttons while you
press the "B" button on the Lighted Door
Control (all three buttons are held).
5. Release buttons when the motor unit lights
blink. It has learned the code. If light bulbs
are not installed, two clicks will be heard.
To Erase All Codes From Motor Unit Memory
To deactivate any unwanted remote, fi rst erase all codes:
Press and hold the "learn" button on motor
unit until the learn indicator light goes out
(approximately 6 seconds). All previous
codes are now erased. Reprogram each
remote or keyless entry you wish to use.
garage door opener is operated with a non-rolling code transmitter, the technical measure in the receiver

To Add or Reprogram a Hand-held Remote Control

"A"
"A"
Button
Button
"B"
"B"
Button
Button

USING THE DOOR CONTROL

1. Press and hold the button on the
hand-held remote* that you wish to operate
your garage door.
2. While holding the remote button, press and
hold the light button on the door control.
"A" "A"
Button Button
3. Continue holding both buttons while you
press the push bar on the door control
"B"
"B"
Button
Button (all three buttons are held).
4. Release buttons when the motor unit lights
blink. It has learned the code. If light bulbs
are not installed, two clicks will be heard.
*3-Button Remote Controls (315 MHz)
If provided with your garage door opener, the large button is
factory programmed to operate
it. Additional buttons on any
Security✚ ® multi-function
remote or mini-remote can
be programmed to operate
other Security✚
openers.
36
®
remote controls.
® garage door