Technical Data
Subject to modification without notice.
General
Power consumption
Active _______________________________ < 20 W
Standby ______________________________ < 0.6 W
Dimensions, w × h × d ____________ 435 × 88 × 310 mm
Weight _______________________________ 5 kg, 8.8 lb
Audio
Frequency response ____________________ 2–20,000 Hz
Playback
S/N (A-weighted) _______________________ 120 dB
S/N __________________________________ 110 dB
Dynamic range __________________________ 98 dB
Total harmonic distortion _________________ -95 dB
Channel separation ______________________ 105 dB
Recording
S/N (A-weighted) ________________________ 93 dB
S/N digital without SRC ____________ equal to source
Dynamic range __________________________ 90 dB
Total harmonic distortion + noise ___________ -86 dB
Digital/optical input ___________________ 12–96 kHz
Laser (CD recorder)
Type ___________________ Semiconductor laser GaAIAs
Wave length ___________________ 775–795 nm (at 25°)
Output power ________ 2.5 mW (Read), 35 mW (Write)
Beam divergence ________________________ 60 degree
As an ENERGY STAR
®
partner,
Philips has determined that this
product meets the ENERGY STAR
guidelines for energy efficiency.
The set complies with the FCC-Rules, Part 15 and
with 21 CFR 1040.10. Operation is subject to the
following two conditions:
1.This device may not cause harmful interference,
and
2.This device must accept any interference
received, including interference that may cause
undesired operation.
CAUTION
Use of controls or adjustments or performance of
procedures other than herein may result in hazardous
radiation exposure or other unsafe operation.
17.1 × 3.5 × 12.2 inches
®
General information
Environmental information
All redundant packing material has been omitted.We have
tried to make the packaging easy to separate into three
mono materials: cardboard (box), polystyrene foam (buffer)
and polyethylene (bags, protective foam sheet).
Your unit consists of materials which can be recycled if
disassembled by a specialized company. Please observe the
local regulations regarding the disposal of packing materials,
exhausted batteries and old equipment.
Supplied accessories
– 2 analog audio cables (with red and white plugs)
– Remote control
– 2 batteries for the remote control, size AA
– Power cable
Maintenance
Clean the unit with a soft,
slightly dampened, lint-free cloth. Do
not use any cleaning agents as they
may have a corrosive effect.
Do not expose the unit, batteries or
discs to humidity, rain, sand or
excessive heat (caused by heating
equipment or direct sunlight).
Disc handling
If the CD player/recorder fails to read discs correctly, use a
commonly available cleaning CD to clean the lenses before
submitting the unit to repair. Other cleaning methods may
destroy the lenses. Always keep the trays closed to avoid
dust on the lenses.
The lenses may cloud over when the unit is suddenly
moved from cold to warm surroundings. Playing a disc is
not possible then. Leave the unit in a warm environment
until the moisture evaporates.
To take a disc out of its box easily,
press the center spindle while lifting
the CD(RW). Always pick up a
CD(RW) by the edge and put it
back in its box after use.
Never write on a CD or attach a
sticker to it.Write only on the printed side of a CDR or
CDRW, and only with a soft felt-tipped pen.
To clean a disc, wipe it in a straight
line from the center toward the
edge using a soft, lint-free cloth. A
cleaning agent may damage the disc!
7