Samsung WB09H7 Serie Manual De Usuario página 17

Step 4 - Connect the drain hose
Installing the drain hose
1. Connect the drain hose (A)to the case pump outlet pipe with
the hose tilted at a 2 o'clock angle.
The drain hose goes over the case pump outlet pipe.
Make sure that you connect the drain hose so that less
than 1/3 in. (10 mm) of the pipe remainsexposed.
2,
3°
4°
Clamp the drain hose using a joint ring (B).
Make sure the joint ring is clamped with its two prongs
facing the washer.
Attach the clamper (C) to the drain hose at the end of the
sponge.
Make sure the clamper covers one end of the sponge.
Make sure the sponge is tightened. A loose sponge may
cause noise whilethe washer is operating.
Insert the included screw through the screw hole inthe
clamped then fix the screw to the hole on the rear right side of
the frame. Tighten with a screwdriver.
X i;" OJ
..........................
;!_Z-_ .....
English : 17