Samsung WB09H7 Serie Manual De Usuario página 18

5. Make sure t he drain h ose i sconnected as shown.
/ iiii i
iJ
ii
CAUTION: Once you havetightened the screw on the clamper, do not loosen it. Otherwise,
water may leak while the washer operates.
Position the drain hose
The end of the drain hose can be positioned inthree ways:
Over the edge of a wash basin
Securethe guide to the side of the basin wall with a hook or
to the tap with a piece of string to prevent the drain hosefrom
moving.
In a standpipe or laundry tub
The standpipe must be no shorter than 39 in (99 cm) and no
longerthan 96 in (245 cm).
• Make sure that the connection between the drain hose
and the standpipe is not airtight.
Connect the hose guide within 4 in (10 cm) of the end
of the drain hose. Ifthe drain hose extends more than
4 in (10 cm) beyond the end of the hose guide, mold
or microorganisms could spread to the inside of the
washer.
Laundry tub
Hose retainer
39"Mir__"-_ _
Standpipe
39,, M _in _ Hose retainer
_Tie strap
\ /
o
The Drain Hose can be installed up to 96 in (245 cm) above the floor, maximum, but the
drainingcapability can be reduced at this height. It can cause the washer to havean
odor because of water remaining inthe drain system.
Ifthe drain hose is installed below 39" (99cm), the syphon effect can cause water to flow
back into the washer during a cycle. Ifthis occurs, the washer displays an "4E" error.
English o 18