Stadler Form Roger Manual De Instrucciones página 10

8. Pressing the button for auto mode (9) automatically adjusts the speed
level to the current air quality (steps 1–4). If the air quality deteriorates,
the device automatically selects a higher speed level. The display shows
"Auto" when auto mode is activated.
9. By pressing the button for the timer (10) you can set the operating time
for between one and seven hours (for example, 3 h = 1 h and 2 h LEDs lit,
7 h = 1 h, 2 h and 4 h LEDs lit). The selected time is displayed above the
timer button with white LEDs. Press once to set the operating time to
1 h, press the button again for 2 h, and so on. The remaining time is indi-
cated by the illuminated LEDs above the timer button. The unit switches
off automatically after the set operating time has elapsed. If no LEDs are
lit above the timer, the unit is set to continuous operation.
10. If you are bothered by the brightness of the LEDs and the air quality
indicator (7) (in a bedroom, for example), you can switch these off by
pressing the button for night mode (11) once. The controls cannot be
switched off completely, but go out automatically after 10 seconds with-
out input.
Press the button for night mode again to return to normal mode.
11. Above the button for HEPA reset (12), four LEDs indicate the life span of
the Dual Filter
be replaced. Reset the timer for the Dual Filter by pressing and holding
the button for HEPA reset (12) (for about 3 seconds). If all 4 LEDs light up
continuously, the timer has been successfully reset.
12. Press the WiFi button (13) to connect Roger/Roger big to the "Smart
Life – Smart Living" App von Tuya Inc. (available in the App Store and
via Google Play) on your smartphone. The illuminated LED above the
WiFi button indicates the connection between Roger/Roger big and
your smartphone. You can control all the functions of the appliance via
the app and monitor the air quality in real time, even when you are not
at home. For more detailed information on how to connect your Roger/
Roger big to your smartphone, see the enclosed „WiFi – Quick Setup
Guide".
Cleaning and filter exchange
Prior to any maintenance, cleaning and after each use, switch off the appli-
ance and unplug the mains cable (4) from the socket. To access the various
filters, please refer to Point 1 of "Setting up / operation".
Attention: Never submerge the appliance in water (danger of short-circuit).
• When cleaning the outside, rub the non-textile parts of your appliance
with a damp cloth and then dry thoroughly.
• The textile pre-filter (1) must be cleaned regularly, once a month depen-
ding on the level of soiling, using the textile brush attachment for your
vacuum cleaner. In the case of heavy soiling, the textile pre-filter (1) can
also be washed in a washing machine. The Sanitized® antimicrobial ma-
terial protection is guaranteed for at least 20 washes. Allergy sufferers
are recommended to wash the textile pre-filter once a month and all other
users every 3 months.
• The textile pre-filter will need to be removed from its plastic frame before
it can be washed in a washing machine. In order to do that, all the material
will need to be removed from the two positioning aids, the two pin, the
4 tabs and the two corner tabs at the top. The textile pre-filter can be
washed at 30° on a gentle cycle. Let the textile pre-filter (1) dry com-
(2). If all four LEDs are flashing, the Dual Filter
TM
must
TM