Headboard Brackets - Ergomotion Contour Elite Gold Manual Del Usuario

headboard bracket installation guide (optional)
Headboard Brackets are optional accessories and are not included.
A 9/16" (14 mm) & 1/2" (13 mm) socket or wrench and legs are necessary to complete installation.
STEP 1
a.) Align the hole in the bracket to the brass sleeve into which the
leg threads. Hold the bracket in place and screw the leg into
the base until it is snug. DO NOT OVERTIGHTEN. Too much
force may cause the leg to spin freely.
b.) Align the tab with the hole in the frame (located towards the
foot of the base) and use a short bolt and nut to secure the
bracket. Make sure the bolt is tight.
STEP 2
Attach the plastic spacer and T-Bracket.
a.) Measure the distance between the mounting holes on the
headboard and install the spacer and attachment plate to
accommodate the headboard.
b.) To install the plastic spacer and attachment plate, you
will need (2) long bolts and (2) nuts. Place the spacer and
attachment plate in the desired location and slip the bolts
through the holes with the head of the bolt facing outward.
Position the bolts diagonally on the spacer. Use the 9/16" (14
mm) socket and wrench to tighten the bolts.
STEP 3
You may now connect your headboard to the attachment plates
using the remaining short bolts and nuts to secure it to the
brackets. The heads of the bolts will face outward. Use a 9/16"
(14mm) socket and 1/2" (13mm) wrench to tighten the bolts.
17